Monte Carlo Fan Company 5DOR52 Series AC-552 Owner's Manual And Installation Manual page 3

1
Before you begin installing the fan, S witch power off
at Service panel and lock service disconnecting means
to prevent power from being switched on accidentally.
When the service disconnecting means cannot be
locked, securely fasten a prominent w arning device,
such as a tag, to the service panel.
4
Remove the 6 screws attaching the Mounting
neck with the mounting plate. R etain the 6
screws for re-assembly.
7
Lift mounting neck to mounting Plate and align
screws.
© 2011 Monte Carlo Fan Company
2
OUTLET BOX METHOD
Warning-Risk of fire, electric shock, or personal
injury. The fan in this bo x may be either directly sup-
ported from a structural framing member of a build-
ing and/or may be mounted to an outlet bo x marked
acceptable for fan support of of 31.8 kg(70lbs) or
less. Most outlet boxes commonly used for the sup-
port of lumminaires may not be acceptable for fan
support and may need to be replaced. Consult a
qualified electrician if in doubt.
5
BUILDING STRUCTURE METHOD
Outlet box
Mounting
Plate
Secure mounting plate directly to a joist from
the buliding structure via the two knock out
holes on the outlet box. Use only the appropri-
ate wood screws and washers included with
your fan.
Caution: Wood screws must go through into
the building joist.
Note:If Installing It In The U.S., Do Not Re-
move Knockouts In The Outlet Box
8
Secure mounting neck to the mounting plate
with 6 screws to become a complete mount-
ing bracket.
3
3
Remove Safety bar from mounting br acket by
loosing screws, sliding bar to side, and lifting it
off the 2 screws.
6
FAN BRACE AND OUTLET BOX METHOD
For Installation in The U.S. only
Wood
Screws
Install the mounting Plate to approved fan
brace and box combination use only the hard-
ware provided with the fan brace and box.
9
Loosen two set screws holding half ball, slide
down ball and remove pin. Remove the ball.
Set screws
4/25/2012