Cradlepoint CTR350 User Manual page 11

Admin
Time
Syslog
Email
System
Firmware
Dynamic DNS
TOOLS Topics
The admin option is used to set a password for
access to the Web-based management. By default
there is not an Admin password (the default
password you are familiar with by now is the User
password).
The Time configuration option allows you to
configure, update, and maintain the correct time.
From this section you can set the time zone that
you are in and set the NTP (Network Time Protocol)
Server. Daylight Savings can also be configured to
automatically adjust the time when needed.
This option allows you to log information about your
network. You can send this information to a Syslog
Server.
The Email option can be used to send your Syslog
information to your e-mail account. You can also
select at what intervals you would like to receive
this information about your network.
The System page allows you to reboot your CTR
router to the factory default settings without using
the hardware Reset button found just inside and
under the battery cover of the unit. Remember,
restoring the Default Factory Settings will erase all
of your configured changes.
The Firmware page allows you to check for and
install the latest version of your CTR software.
Upgrades improve the functionality and
performance of the CTR. You can set the CTR to
notify you by E-Mail when a newer version of the
software is available.
The DDNS feature allows you to host a server (Web,
FTP, etc) using a domain name that you have
purchased (www.yourchoiceofname.com) with your
dynamically assigned IP Address. Most Broadband
Internet Service Providers assign dynamic
(changing) IP Addresses. Using a DDNS service
provider, your friends can enter your host name to
connect to your server no matter what your IP
address is.
10
Set Admin Password
Set User Password
Administration and Remote Settings
Enable / Disable UPnP
Save and Restore Configuration
Time zone and Daylight savings settings
Enable / Disable and set NTP Server
Set the date and time manually
Allows for you to copy your computer's current
time settings.
Enable / Disable Syslog Server
Set Syslog Server IP Address
Enable / Disable E-mail Notification
Set Email Settings
Set Email Notification Schedule
Reboot the Device
Restore all Settings to the Factory Defaults
Firmware information and latest version check
Download Firmware Upgrade section
Set Firmware Upgrade notification options
Enable / Disable DNS
Dynamic DNS Settings