Washing Cycles - Russell Hobbs RH45BISLDW2 Instruction Manual

Washing Cycles

Turning on the appliance
Starting the wash cycle
1. Pull out the lower and upper basket, load the dishes and push them back. It is recommended
to load the lower basket first, then the upper one (see the loading the dishwasher section).
2. Pour in the detergent powder or put in the detergent tablet into the detergent dispenser
(see the detergent section) and close the detergent dispenser cover.
3. Insert the plug into the socket. The power supply must be 220-240 AC / 50 HZ,
4. Make sure that the water supply is turned on to full pressure.
5. Press the ON/OFF button (the ON indicator will light up)
6. Select your required program by pressing the PROGRAM button (the indicator light of the
program you have selected will light up) .
7. If required and if the program is compatible with the function you should select half load
and/or delay timer functioned.
8. Then close the door, the machine will beep and the washing cycle will begin.
Change the program
A cycle that is underway can only be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the
Detergent section).
If you wish to change the program and it is possible, then open the appliance door, press and
hold the PROGRAM button for more than 3 seconds. The machine will enter the standby state,
at this point you can now select the program you require by pressing the PROGRAM button.
Once this has been done close the door and the wash cycle will begin.
Note: If you open the door during a wash cycle, the machine will pause. The program light will
stop blinking and the buzzer will beep every minute unless you close the door. After you close
the door, the machine will continue to work after 10 seconds.
Time delay
The starting time of a washing programme can be delayed, please follow the steps below:
1. Open the dishwasher door, load your soiled dishes/crockery and add detergent.
2. Press the on/off button to turn on the dishwasher and select your preferred program.
3. Press the Time Delay button and set the required delay start time (this will be shown by time
delay the indicator lights).
4. Close the door and the unit will start the programme at the assigned time automatically.
For Customer Services & Spare Parts please call 0345 208 8750
Opening times: Monday - Friday 8am – 8pm & Saturday 9am – 1pm
or visit us at www.productcare.co.uk
26