G3D T-1000 Quick Start Manual page 4

UNBOXING ANG SETTING UP THE T-1000
UNTIGHTEN THE VAT STOPPERS
13
Rotate the (4) four vat stoppers counter clockwise
to loosen, no need to remove the vat stoppers from
the VAT insert.
INSERT THE VAT
14
TIGHTEN THE VAT STOPPERS
15
Tighten the (4) four VAT stoppers only enough to
snug them against the VAT. Do not overtighten the
VAT stoppers because it can damage the VAT.
PLUG THE POWER CABLE
16
Insert the power cable into a power outlet.
Uninterruptible power supply recommended.
TURN ON THE MAIN SWITCH
17
Press the main switch on, located at the back panel
of printer.
PRESS THE POWER BUTTON
18
Push power button for 2 - 3 seconds until a red led
illuminates from the power button.
VAT INSERT