Canon imagePRESS C8000VP Quick Manual page 59

Product Name
Safety regulations require the product's name to be registered. In some regions where this product is sold, the following name(s) in
parenthesis may be registered instead.
imagePRESS C10000VP/C8000VP (F164400)
FCC (Federal Communications Commission) Users in the U.S.A.
Contains Transmitter Module FCC ID: AZDFM1M944
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate, radio frequency energy and, if not installed and used in
accordance with the Operator's Manual, may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
If this equipment does cause harmful interference to other equipment, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Increase the separation between the equipment and other equipment.
•
Connect the equipment into an outlet on a circuit different from that to which the other equipment is connected.
•
Consult the dealer for help.
Use of shielded cables are required to comply with Class A limits in Subpart B of Part 15 of the FCC Rules.
Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If you make such changes or
modifications, you could be required to stop operation of the equipment.
If your equipment malfunctions, please contact your local authorized Canon dealer from whom you purchased the equipment (if
under warranty), or with whom you have a servicing contract. If you are not sure who to contact, and have both purchased and are
using the equipment in the U.S.A., please refer to the "SUPPORT" page on Canon U.S.A. ' s Web site (http://www.usa.canon.com).
59