Siemens SIMATIC NETS7-1200 Operating Instructions Manual page 70

Telecontrol cp 1242-7
Hide thumbs Also See for SIMATIC NETS7-1200:
Table of Contents

Advertisement

Configuration
5.4 Configuring the telecontrol instructions
Field for monitoring times
In STEP 7, the corresponding data is located in the parameter areas "Acknowledgment
monitoring" and Operating mode".
Table 5- 13
IF_CONF_TC_Timeouts
Parameter
Id
Length
Mode
KeepAliveTimeout
SendTimeout
RedialTimeout
Field for the "Wake up right" parameter area
Table 5- 14
IF_CONF_WakeupList
Parameter
Id
Length
Mode
WakeupPhone [1...10]
Field for the "Preferred GSM networks" parameter area
Table 5- 15
IF_CONF_PrefProvider
Parameter
Id
Length
70
Data type
Initial value
UINT
12
UINT
UINT
-
-
UINT
UINT
Data type
Initial value
UINT
13
UINT
UINT
ARRAY [1...10]
of STRING [22]
Data type
Initial value
UINT
14
UINT
Description
ID of the parameter field
Length of the parameter field in bytes: 12
Validity (1: permanent, 2: temporary)
- Reserved - (cannot be set)
Acknowledgment monitoring time: Monitoring time for the
arrival of the TCP acknowledgment from the
communications partner after sending frames (seconds)
Only relevant for telecontrol connections
Dialing repetition delay: Basic value for the wait time until
the next attempt to establish a connection following an
unsuccessful connection establishment. After every 3
attempts, the basic value is doubled up to a maximum of
900 s. Range of values: 10 to 600 s. If a substitute
telecontrol server is configured, the CP attempts to
connect to it at the 4th dialin attempt. Example: Basic
value 20 results in the following dialing intervals: three
times 20 s, three times 40 s, three times 80 s etc. up to a
maximum of 900 s.
Not relevant for SMS connections
Description
ID of the parameter field
Length of the parameter field in bytes: 246
Validity (1: permanent, 2: temporary)
Phone number subscriber authorized to wake up
The asterisk (*) at the end of a call number is used a
placeholder for direct dialing numbers.
Description
ID of the parameter field
Length of the parameter field in bytes: 46
Operating Instructions, 09/2011, C79000-G8976-C247-02
CP 1242-7

Advertisement

Table of Contents
loading

Table of Contents