Siemens SIMATIC NETS7-1200 Operating Instructions Manual page 45

Information required in "Telecontrol" mode
● Address of the telecontrol server
● DNS server address(es)
Information for TeleService
● TeleService user name
● TeleService password
● Server password
CP 1242-7
Operating Instructions, 09/2011, C79000-G8976-C247-02
– IP address
or
– Name of the telecontrol server that can be resolved by DNS
– Port number
The relevant station type-dependent number of the listener port is configured in the
telecontrol instructions.
If you install a substitute telecontrol server: Address and port of the substitute telecontrol
server
You require the DNS server address if you address the telecontrol server using a name
that can be resolved by DNS.
– If you do not specify an address, the DNS server address is obtained automatically
from the network provider (recommended procedure).
– If you want to use a different DNS server, enter its address.
To authenticate the user with the CP
– Configuration of the CP in STEP 7. You can configure up to 10 TeleService users.
– Entry at the engineering station
To authenticate the user with the CP
– Configuration of the CP in STEP 7
– Entry at the engineering station
To authenticate the CP with the telecontrol server
– Configuration of the telecontrol server
– Entry at the engineering station
If no server password is configured on the telecontrol server, no server password
needs to be entered when establishing the TeleService connection.
5.2 Information required for configuration
Configuration
45