Table of Contents
Advertisement
Setting the Operating Mode
In addition to the settings for the dedicated line, the operating mode of the modem
needs to be specified. The "Normal" operating mode is usually used for the
SINAUT ST1 system.
Table 3-5
Setting on
DIL Switch
OFF
ON
1 2 3 4
Setting the Character Recognition
The character recognition is set on switches 5 to 7 of the 10-pin DIL switch.
Table 3-6
Setting on
DIL Switch
OFF
ON
1 2 3 4
© Siemens AG 2002 All Rights Reserved
MD2 Modem (07/2002)
Settings on the 10-pin DIL switch (operating modes)
Meaning
Normal operating mode
This mode must be selected when the MD2 is connected through its
RS232 interface to a terminal.
5 6 7 8 9 10
Settings on the 10-pin DIL switch (character format)
Meaning
Character recognition asynchronous 11 bit :
In this mode a message consists of a series of asynchronous
characters, 11-bit each (1 start bit, 8 data bits, 1 parity bit, 1 stop bit).
This is the standard setting for sending SINAUT ST1 or SINAUT ST7
5 6 7
8 9 10
messages. In this case message format FT 1.2, based on 11-bit
asynchronous characters, is normally used for transmitting over
dedicated lines.
Instructions for Operation with SINAUT ST1
6NH7811-0AA22
3-5
Advertisement
Chapters
Table of Contents
