Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for EDIFIER W830BT
Summary of Contents for EDIFIER W830BT
- Page 1 Walker W830BT Bluetooth stereo headphones Operating instructions...
- Page 2 ■ Product introduction Before using this device, please read this manual carefully and keep it safe for future reference. Features ● 40mm Nd-Fe-B unit with high quality sound in strong low frequency; ● Long battery life design to save worry. It works for about 15 hours and standby xx hours;...
- Page 3 ■ Package list Headphones*1 pcs Storage bag*1 PCS Manual*Warranty card 1 PCS each USB charging cable*1 pcs 3.5mm audio wire*1 PCS ■ Operation instructions 1. Illustration 1.1 Press volume up/Press and hold last song 1.2. Multi-function key 1.3 Press volume down/Press and hold next song 1.4 Micro USB charging port 1.5 3.5mm audio port...
- Page 4 2. Charging The headphones use the built-in rechargeable batteries. The batteries must be fully charged before use the headphones. In use, one beep sound every minute and the red light quickly flashing three times indicate that the battery life is low and you need to charge the headphones.
- Page 5 If your Bluetooth mobile supports Near Field Communication (NFC), please enable NFC of your mobile at first and switch on the headphones, then touch the NFC area of W830BT with the NFC area of your mobile. W830BT shall pair up with your mobile.
- Page 6 steps are as below: 2.3.1. Firstly the headphones connecte the device one. 2.3.2. Switch off the headphones and then press and hold multi-pad 3 seconds to restart the headphones and enter the pairing status to connect the device two. 2.3.3. Now operate on the device one. Click the headphones among the Bluetooth connection settings to complete the headphones in connection with two devices;...
- Page 7 call 2 seconds Cancel call Talking Press the multi-function key Increase volume Talking Press the volume + key Decrease volume Talking Press the volume - key Talking transferred Talking Press and hold multi-pad about to mobile 2 seconds Talking transferred Talking Press and hold multi-pad about to headphones...
- Page 8 mobile’s incoming call incoming call Double click multi-function Switch calls Talking, a call is remained Hang out the current call, Press the multi-function Get back to the remained Talking, a call is remained key one time mobile 4. Play music 4.1.
- Page 9 connection automatically disconnected. AUX in audio input is validated. ● If using Bluetooth, please unplug 3.5 audio wire and restart and power on to pair up the connection. 5. Restore factory settings Ensure the headphone is power off and meanwhile press and hold Volume + key and multi-pad about 3 seconds.
- Page 10 circuit. ● Do not place the product at the places exposed to sun or in high temperature. High temperature would shorten the service life of electronic components, damage battery and make some plastic components deformed. ● Do not place the product at very cold places to prevent damaging the internal circuit board.
- Page 11 b. When the headphones are not used for a long time, the battery will enter the hibernate status. Now it needs to charge about 30 minutes and then the red light shall be on. 3. The headphones hear nothing. Answer: a. Ensure if the headphones are in work status. b.
- Page 12 CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. A warning that batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Correct Disposal of this product.
- Page 13 sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling. To prevent possible hearing damage, do not listen at high volume levels for long periods.
- Page 14 Manufacturer: Dongguan Edifier Technology Co., Ltd Address: No. 2, Gongye Dong Lu, Dongguan Songshan Lake Hi-tech Industrial Development Zone ○ ○ Trademark: EDIFIER , Walker both are the registered trademark of Beijing Edifier Technology Co., Ltd. Counterfeiting is not allowed. Version No. Ver1.0 IB-100-W0830B-00...
- Page 15 NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 16 This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1)this device may not cause interference, and (2) this device must accept any interference, includinginterference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables auxappareils radio exempts de licence.
Need help?
Do you have a question about the W830BT and is the answer not in the manual?
Questions and answers
can i use these headphones for corded monitoring without the 3.5 millimeter stereo jack. my model does not have one
No, the Edifier W830BT headphones require a 3.5mm male connector for corded use, so they cannot be used for corded monitoring without a 3.5mm stereo jack.
This answer is automatically generated