Siemens SCALANCE XP-200 Operating Instructions Manual page 70

Upkeep and maintenance
5.2 Restoring the factory settings
6. Release the button and wait until the fault LED "F" goes off.
The device starts automatically with the factory settings.
7. Close the cover (tightening torque 0.8 Nm), to ensure that the device is closed and water
and dust proof.
Restoring the factory defaults during operation
You can reset the device to the factory defaults during operation, see section "RESET button
(Page 33)".
With the Primary Setup Tool
Follow the steps below to reset the device parameters to the factory defaults with the
Primary Setup Tool.
1. Select the device whose parameters you want to reset.
2. Click on the menu item "Reset" in the "Module" tab.
3. Confirm the prompt with "OK".
During configuration
You will find detailed information on resetting the device parameters using the WBM and CLI
in the configuration manuals see also section "Introduction (Page 3)":
● SCALANCE XB-200/XP 200 Web Based Management, section "Restart"
● SCALANCE XB-200XP-200 Command Line Interface, section "Reset and Defaults"
70
Operating Instructions, 05/2016, C79000-G8976-C428-01
SCALANCE XP-200