Using Stereo/Direct; Using Advanced Surround - Pioneer VSX-D711 Operating Instructions Manual

Playing sources
If you are listening to a two channel source,
each press changes the display as follows:
Pro Logic II Movie
Pro Logic
NEO:6
Music*
* VSX-D811S only
Refer to page 32 for more details about each
mode.
4 Start playback of the component you
selected in step 1.

Using Stereo/Direct

When you select STEREO or DIRECT, you will
hear the source through just the front left and
right speakers (and possibly your subwoofer
depending on your speaker settings). Dolby
Digital and DTS multichannel sources are
downmixed to stereo. See page 32 for more on
these modes.
• Press STEREO (STEREO/DIRECT on the
front panel) repeatedly to switch between
the two options.
If you switch on Midnight listening,
Loudness, or the Tone controls when
DIRECT is selected, the receiver automati-
cally switches to STEREO.
XRB3013A.32.37

Using Advanced Surround

When you select one of the Advanced surround
options, Dolby Pro Logic, Dolby Digital and DTS
decoding is done automatically corresponding
to the input signal. Use Advanced surround to
Pro Logic
add effects to the surround sound.
II Music
•
NEO:6
ROUND) repeatedly to cycle the sound
Cinema*
options.
Each press changes the display as follows:
* VSX-D711
** VSX-D811S
Refer to page 33 for more details about each
surround effect.
35
Press ADV.SURR. (ADVANCED SUR-
Movie Music
5-Stereo*/
Expanded
6-Stereo**
The Advanced surround effects can be
adjusted in the range of 10 to 90 (the
default setting is 70) by pressing RCV then
pressing EFFECT +/– . The effect level can
be set for each Advanced surround mode.
The Standard mode cannot be changed.
01.12.12, 4:44 PM
05
Virtual SB
35
En