Table of Contents
Advertisement
03
Connecting up
• When using the speaker on your TV as the center speaker (C), connect the CENTER PREOUT
jack on this unit to the audio input jack on your TV. In this case the center speaker shown is
unnecessary.
• If you are using only one surround back speaker, connect the positive wire to the right channel
(+) terminal, and the negative wire to the left channel (–) terminal (see illustration on page 11).
• If you select subwoofer (SB SUBWF) in the Surround back speaker setting (see page 39) you can
hook up a subwoofer instead of speakers to the surround back speaker terminals. Connect the
positive wire to the right channel (+) terminal, and the negative wire to the left channel (–)
terminal (see illustration on page 11).
Speaker terminals
1
Twist exposed wire strands together.
2
Loosen speaker terminal and insert exposed wire.
3
Tighten terminal.
Make sure that all the bare speaker wire is twisted together and inserted fully into the speaker
terminal. If any of the bare speaker wire touches the back panel it may cause the power to cut off as
a safety measure. Use good quality speaker wire to connect the speakers to the receiver.
A and B speaker systems
The receiver has two speaker systems: A and B. A is the main system supporting the full speaker
setup. If you switch on both A and B speaker systems, only the front speakers and the subwoofer
will be audible. No sound will come from the center, surround, or surround back speakers, but
multi-channel sources will be down-mixed to the active speakers so no sound will be lost. Similarly,
if you choose just the B system you'll only hear the front speakers connected to the B system and
multi channel sources will be down-mixed to these two speakers.
Hints on speaker placement
Speakers are usually designed with a particular placement in mind. Some are designed to be
floorstanding, while others should be placed on stands to sound their best. Some should be placed
near a wall; others should be placed away from walls. We have provided a few tips on getting the
best sound from your speakers (below), but you should also follow the guidelines on placement that
the speaker manufacturer provided with your particular speakers to get the most out of them.
• Place the front left and right speakers at equal distances from the TV.
• When placing speakers near the TV, we recommend using magnetically shielded speakers to
prevent possible interference, such as discoloration of the picture when the TV is switched on. If
you do not have magnetically shielded speakers and notice discoloration of the TV picture, move
22
the speakers farther away from the TV.
En
XRB3013A.13.25
The speaker terminals also
accept single banana
plugs. (Refer to speaker
manual for details.)
22
3/8 in. (10mm)
01.12.12, 4:43 PM
Advertisement
Table of Contents
