Table of Contents
Advertisement
06
Setting up the receiver
Surround back speaker distance
setting
(VSX-D811S only)
• Default setting: 10 ft.
Like the center speaker, you should set the
distance of the surround speakers accurately to
hear sounds coming from both front and
surround speakers at the same time.
Use ' or ' to set the distance of the
•
surround speakers from the main listening
position (within a 30 foot range).
When SB is selected in the surround
speaker setting, the surround back
speaker distance can't be set.
Dynamic range control setting
• Default setting: OFF
Dynamic range is the difference between the
loudest and softest sounds in any given signal.
With this setting, you can compress the
dynamic range, so that low level sounds can be
heard more easily (sounding relatively louder)
yet louder sounds won't be too overbearing.
Press ' or ' to set the dynamic range
•
control (OFF, MAX, or MID).
• When the volume level is increased, set to
OFF.
• When listening at low volumes, set to
MAX for maximum dynamic range
compression.
• Dynamic range control is effective only
when a Dolby Digital signal is being played
back.
42
En
XRB3013A.38.44
Dual mono setting
• Default setting: ch1
The dual mono setting can only be used when
listening to Dolby Digital discs with dual mono
encoding. These discs are not widely used, but
are sometimes used when it is necessary to
have one language on one channel and a
different language on the other. With this
setting you can choose which channel in the
dual mono setting you want to listen to.
If Dolby Digital mode is switched on, you will
hear the channel you have selected (either ch1
or ch2) through your center speaker. With Dolby
Digital mode off, or if you don't have a center
speaker, you will hear the channel you have
selected through both front speakers. In the L
ch 1. R ch 2 setting, the left front speaker will
play channel 1 and the right front speaker will
play channel 2.
•
possible dual mono settings.
Component video input settings
Here you tell the receiver what components you
have hooked up to the component video jacks
on the back of the receiver.
Component video 1:
• Default settings: DVD
1
video 1 input (DVD, TV, VCR or OFF).
Component video 2:
• Default setting: TV
2
video 2 input (DVD, TV, VCR or OFF).
42
Use ' or ' to cycle through the
L ch 1.R ch 2
ch2
ch1
Use ' or ' to assign the component
Use ' or ' to assign the component
01.12.12, 4:46 PM
Advertisement
Table of Contents
