Control Panel Mounting; Mains Power Connection - 3P Technik TC320 Installation And Operating Manual

Control Panel Mounting

Having selected a suitable location, unlock the 4 locking screws on the corners of the front cover and
withdraw the front panel. The LCD display, buttons and alarm LED are connected to the PCB. Remove and
replug these cables afterwards if necessary in accordance with the diagram.
The 4 screw mounting holes are located on the main enclosure in recesses adjacent to the front panel
mounting holes. Mark drilling points on the wall accordingly. Withdraw the casing from the wall and drill
holes appropriate for your selected fixings.

Mains Power Connection

The power supply to the control panel enters via a cable gland on the bottom right of the housing. Insert
the cable, connect to the incoming power terminal on the right of the PCB, and tighten the cable gland.
TC Series Controller v1.30
www.3ptechik.co.uk 09-August-2017 Page 6 of 28