Bms Output; Output Control Outputs (Left To Right); Upgrades And Modifications - 3P Technik TC320 Installation And Operating Manual

BMS Output

Type – Non contact relay
Terminals – Common, Normally Open, Normally Closed
Power Rating max 10A 230Vac

Output Control Outputs (left to right)

1 – Output 1
2 – Output 2
3 – Output 3
4 – Output 4

Upgrades and Modifications

The following parts of the system can be upgraded at any time without any modification to the control
panel.
Replacement/upgrade of pump(s)
Replacement/upgrade of solenoid(s)
Note – there is no need to reprogram or adjust the control panel settings when replacing a pump with
one of a different power output or consumption. Diagnostic functions are not dependent on current
monitoring.
Installation of 3 phase pump(s) via external contactor/relay.
Software upgrade by either on-site reprogramming, or by CPU replacement. Reprogramming is unlikely to
ever be necessary, but is provided for to allow for custom software to be retrofitted to the control panel. It
is carried out by an approved engineer via an on-board programming port, or via replacement of the CPU.
The CPU is socketed in a 40pin DIP socket for ease of replacement. The CPU is a
When replacing the CPU, always use a proper DIP Extraction Tool, and follow the instruction provided with
the replacement CPU.
TC Series Controller v1.30
www.3ptechik.co.uk 09-August-2017 Page 10 of 28