Table of Contents
Advertisement
47
Low Level Alarm – Tank 2
48
Low Level Alarm – Tank 1
49
Low Level Alarm – Tank 2
50
Low Level Alarm – Tank 1
51
Low Level Alarm – Tank 2
52
Low Level Alarm – Tank 1
53
Low Level Alarm – Tank 2
54
Low Level Alarm – Tank 1
55
Low Level Alarm – Tank 2
56
Low Level Alarm – Tank 1
57
Low Level Alarm – Tank 2
58
Low Level Alarm – Tank 1
59
Low Level Alarm – Tank 2
60
Low Level Alarm – Tank 1
61
Low Level Alarm – Tank 2
62
Low Level Alarm – Tank 1
63
Low Level Alarm – Tank 2
128
Probe Failure – Tank 1
129
Probe Failure – Tank 2
Clear Logged Fault Codes (Menu>Diags>Faults>Clear)
Selecting this option deletes all stored fault codes.
Run
Returns to the main screen and resumes operation.
Stop
At any time while the system is running (i.e. not in a menu setting), the operation of the panel, pumps and
solenoid can be halted by pressing STOP. Unlike pressing Menu, this option will activate the BMS output to
indicate that the unit has been halted for a purpose other than configuration. It is expected that this button
may be used by persons with no knowledge of the system and/or no access to the Operation Manual.
Under this setting there are 3 options.
Menu (Stop>Menu)
Enters the main system menu (see 3.3), thus allowing fault to be inspected and cleared.
TC Series Controller v1.30
www.3ptechik.co.uk
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
-
-
-
-
09-August-2017
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
-
-
-
-
Page 21 of 28
Advertisement
Table of Contents
Troubleshooting
