Table of Contents
Advertisement
Wipe Configuration (Stop>Wipe Config)............................................................................................22
Troubleshooting...........................................................................................................................................22
Fuse Listing..............................................................................................................................................23
Inputs (left to right) - Con1.....................................................................................................................24
Pressure Sensor Inputs (left to right)......................................................................................................26
BMS Output (con5)..................................................................................................................................26
Outputs (left to right)..............................................................................................................................26
Upgrades and Modifications....................................................................................................................27
Specifications..........................................................................................................................................28
Control Panel................................................................................................................................................28
Tank Level Sensor.........................................................................................................................................28
Switched Outputs (pump/solenoid control)................................................................................................28
Safety
Mains Voltage - There are exposed electrical conductors inside this appliance. This appliance must be
installed and serviced by a competent electricical technician to the current requirements of BS7671 and
IEEE recommendations.
Before servicing this appliance, normal safe isolation procedures should be implemented.
Do not touch the PCB while energised, it carries mains voltage.
Do not touch any connection terminals while energised.
Do not attempt to service this item when wet, or in a wet or high humidity environment.
If the housing of the control panel becomes damaged, you must shut down and securely isolate this
appliance immediately.
You must connect this appliance to a grounded 3 wire supply, protected by suitable overload protection.
Connected pumps and solenoids are earthed via the control panel, and may otherwise become live.
If the power cables are damaged, either to of from the controller then shut down and isolate this apliance.
The combined loading of pumps, etc. connected t this appliance must not exceed 20A using the supplied
mains flex. Contact the manufacturer for advice if you need to exceed this rating.
Do not attempt to repair any part of the circuit board. Refer to the manufacturer for advice.
Installation
Included Components
1 x Control Panel
1 x 2m Mains Flex 2.5mm
TC Series Controller v1.30
www.3ptechik.co.uk
09-August-2017
Page 3 of 28
Advertisement
Table of Contents
Troubleshooting
