Using Other Functions; Recording From Audio Components - Pioneer Elite VSX-24TX Operating Instructions Manual

Using Other Functions

Recording from Audio Components

The following explanations show you how to record an analog audio signal with the component you connected to the
MD/TAPE 1 or TAPE 2 MONITOR jacks. Note that you cannot record an component that is only connected digitally. If you
want to record from a digital component it must be connected in an analog manner as well. If you want to record a
digital signal see the next page.
memo
The receiver's volume, channel level, tone (BASS, TREBLE, and LOUDNESS), and surround effects have no
effect on the recorded signal and the EXTERNAL 5.1 CH input cannot be recorded.
S0URCE RECEIVER
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1 VCR2
MULTI CONTROL
MD/
CD TUNER TVCONT
TAPE1
CLASS MPX BAND DIRECT ACCESS
¶ 7 3 8
- + - +
TUNING STATION
1 ¡ 4 ¢
-
+
DTV ON/OFF DTV MENU CHANNEL
2 3
1
5 6
4
7 8 9
GUIDE
0
ENTER
+10
TV
TV VOL TV CONTROL VOLUME
TV FUNC
EFFECT
MENU MUTE
/CH SEL
FUNCTION
ENTER
SIGNAL
SELECT
/dts
SYSTEM
THX ADVANCED
STANDARD
SETUP
REMOTE
MIDNIGHT DSP STEREO
SETUP
DIGITAL NR
DIGITAL MULTI PROCESSING AMPLIFIER
REMOTE CONTROL
60
1
Î
1
2
3
EXIT
DISC
Record monitor (TAPE 2 MONITOR)
If you connect a cassette deck (etc.) with a record monitor function to
the TAPE 2 MONITOR jacks, you can listen to the sound of the
recording as it is recorded.
Press TAPE 2 MONITOR to switch between the sound of
the recording (TAPE 2 indicator on) and the sound of the
source component (TAPE 2 indicator off).
Select the source component and put the receiver in
that function. Remember, SIGNAL SELECT must be
set to analog.
Press the SIGNAL SELECT button on the remote control (or use
the button on the front panel) and choose ANALOG. Recording
DIGITAL or AC-3 RF (VSX-27TX only) signals is not possible.
Start recording with a TAPE or MD (etc.).
Playback the source to be recorded.