Table of Contents
Advertisement
Other functions
Setting the video signal for the
rear view camera
When you connect a rear view camera to this product, select the
suitable video signal setting.
p You can operate this function only for the video signal input
into the AV input.
1 Display the "Video Setup" screen.
2 Touch [Video Signal Setting].
3 Touch [Camera].
The pop-up menu appears.
4 Touch the item you want to set.
Auto (default): Adjusts the video signal setting
automatically.
PAL: Sets the video signal to PAL.
NTSC: Sets the video signal to NTSC.
PAL-M: Sets the video signal to PAL-M.
PAL-N: Sets the video signal to PAL-N.
SECAM: Sets the video signal to SECAM.
Resetting various settings/
Restoring this product to the
default settings
You can restore settings or recorded content to the default
settings. Various methods are used to clear user data.
Method 1: Remove the vehicle battery
Resets various settings registered to this product.
p The settings configured on the "Theme" screen are not
reset.
Method 2: Initialise from the "System" menu
Method 3: Press the RESET button
Resetting the microprocessor on page 4
Restoring the default settings
p This setting is available only when you stop your vehicle in a
safe place and apply the handbrake.
24
CAUTION
Do not turn off the engine while restoring the settings.
1 Display the "System" setting screen.
2 Touch [Restore Settings].
A message confirming whether to initialise the settings appears.
3 Touch [Restore].
p The source is turned off and the Bluetooth connection is
disconnected before the process starts.
Appendix
Troubleshooting
If you have problems operating this product, refer to this section.
The most common problems are listed below, along with likely
causes and solutions. If a solution to your problem cannot
be found here, contact your dealer or the nearest authorised
Pioneer service facility.
Problems with the AV screen
The screen is covered by a caution message and the video
cannot be shown.
The handbrake lead is not connected or applied.
— Connect the handbrake lead correctly, and apply the
handbrake.
The handbrake interlock is activated.
— Park your vehicle in a safe place and apply the handbrake.
The audio or video skips.
This product is not firmly secured.
— Secure this product firmly.
No sounds are produced. The volume level will not rise.
Cables are not connected correctly.
— Connect the cables correctly.
The picture is stretched, with an incorrect aspect ratio.
The aspect setting is incorrect for the display.
— Select the appropriate setting for that image.
iPod cannot be operated.
The iPod is frozen.
— Reconnect the iPod with the USB interface cable for iPod /
iPhone.
— Update the iPod software version.
An error has occurred.
— Reconnect the iPod with the USB interface cable for iPod /
iPhone.
— Park your vehicle in a safe place, and turn off the engine.
Turn the ignition key back to off (ACC OFF). Then restart
the engine, and turn the power to this product back on.
— Update the iPod software version.
Cables are not connected correctly.
— Connect the cables correctly.
Advertisement
Table of Contents
