Table of Contents
Advertisement
PTX10008 Router Quick Start Guide
Install DC Power Supplies
24
Fasten the cord retainer by lowering the clip over the cord and pushing the cord into
15.
the adjustment nut of the cord retainer. Rotate the nut until it is tight against the base
of the cord. See
Figure 21 on page
Figure 21: Power Cord and Retainer Clip
1—
INP1
Enable switch for
WARNING:
Ensure that the power cords do not block access to router
components or drape where people can trip on them.
If the AC power source outlets have a power switch, set them to the on (
16.
Move the enable switches for input 1 and input 2 to the
17.
Verify that the
and
INP1
18.
steadily.
Press the power switch to the on (
19.
PTX10008 power supplies are hot-insertable and are field-replaceable units (FRUs).
You can install up to six power supplies in a PTX10008. The power supplies install in the
rear of the chassis in the slots provided along the left side.
CAUTION:
Do not mix AC and DC power supplies in the same chassis.
Before you install a DC power supply in the chassis, ensure that you have followed all
1.
safety warnings and cautions:
24.
2—
Enable switch for
LEDs on the power supply faceplate are lit and are on
INP2
) position.
|
INP2
) position.
|
position.
ON
Copyright © 2017, Juniper Networks, Inc.
Advertisement
Table of Contents
