Install Ac Power Supplies - Juniper PTX10008 Quick Start Manual

Install AC Power Supplies

Copyright © 2017, Juniper Networks, Inc.
Place the chassis grounding lug and cable over the PEM nuts with the cable connection
5.
pointing to the left. See
Figure 18: Connecting a Grounding Cable to the PTX10008
Place the two screws over the grounding lug and grounding cable.
6.
Tighten the two screws using a Phillips screwdriver.
7.
Dress the grounding cable and ensure that it does not touch or block access to other
8.
device components and that it does not drape where people can trip over it.
PTX10008 power supplies are hot-insertable and are field-replaceable units (FRUs).
You can install up to six power supplies in a PTX10008. The power supplies install in the
rear of the chassis in the slots provided along the left side.
CAUTION: Do not mix AC and DC power supplies in the same chassis.
Before you install an AC power supply in the router, ensure that you have the following
parts and tools available to install an AC power supply in a PTX10008:
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, number 1
Power cords appropriate for your geographical location.
Power cord retainer clips
To install an AC power supply in a PTX10008 :
Figure 18 on page 21.
Install AC Power Supplies
21