Advertisement
(4) Disengage one hook a engaged bottom side of the Front
panel. (See Fig.4)
(5) Disengage two hooks b engaged both side of the Front
panel. (See Fig.6)
b
hook
(6) Disconnect the card wire from main board connected to
connector
CN531
of the Touch sensor board. (See Fig.7)
(7) Disconnect the card wire from Main board connected to
connector
CN302
of the Front jack board. (See Fig.7)
(8) Disconnect the connector wire from Main boards connect-
ed to connector
CN301
Fig.7)
3.1.3 Removing the Top chassis (See Fig.8 to 10)
(1) Disconnect the card wires from Amp board connected to
connectors
CN201
and
Fig.8)
(2) Disconnect the connector wire from Power supply unit con-
nected to connector
CN103
(3) Disconnect the connector wire from Main board connected
to connector
CN104
of the Amp board. (See Fig.8)
CN202
Fig.6
of the DVD module board. (See
CN301
CN531 CN302
Fig.7
CN202
of the Main board. (See
of the Amp board. (See Fig.8)
CN201
CN103
CN104
Fig.8
(4) Remove the nine screws E attaching the Top chassis. (see
Fig.9)
(5) Remove the four screws F attaching the both side of the
Top chassis. (See Fig.10)
3.1.4 Removing the Amp board (See Fig.11)
(1) Remove the three screws G attaching the Heat sink.
(2) Remove the four screws H attaching the Amp board.
E
Fig.9
F
Fig.10
G
H
Fig.11
(No.MB695<Rev.001>)1-7
Advertisement
