Administration; Factory Default Restore; Backup & Restore - TP-Link AC50 Configuration Manual

HTTP Server Port
Redirect HTTP to
HTTPS
HTTPS Server Port
Web Idle Timeout

9.2 Administration

9.2.1 Factory Default Restore

Choose the menu System Tools > Administration > Factory Default Restore to load the
following page.
Figure 9-4 Factory Default Restore
Click Factory Restore to restore your device to its factory default settings.
Factory Restore will clear all the configurations. It is highly recommended to back up your
current configurations in case a recovery is needed to restore the system to a previous
state or from the factory defaults.
The device will reboot after the factory restore is complete.
9.2.2 Backup & Restore
Choose the menu System Tools > Administration > Backup & Restore to load the following
page.
Specify the web server port. Port 80 is the default. The port should not be the
the same as other service ports.
With redirect HTTP to HTTPS enabled, the http website will be redirected to
https website automatically when you log in to the management web page.
Specify the secure web server port. Port 443 is the default. The port should not
be the same as other service ports.
If the device does not perform any tasks in the specified time interval, the
system will log out automatically to secure the device and network. The default
setting is 6 minutes.
100