Using The Multi-Zone Controls - Pioneer VSX-819H-S Operating Instructions Manual

07 Using the MULTI-ZONE feature

Using the MULTI-ZONE controls

The following steps use the front panel controls
to select sources. See MULTI-ZONE remote
controls below.
STANDBY/ON
PHASE
CONTROL
BAND TUNE –
INPUT AUTO SURROUND/
SELECTOR STREAM DIRECT
PHONES
SPEAKERS
1 Press the MULTI-ZONE ON/OFF button
on the front panel.
Each press selects a MULTI-ZONE option:
• ZONE 2 ON – Switches the MULTI-ZONE
feature on
• ZONE 2 OFF – Switches the MULTI-ZONE
feature off
The ZONE indicator lights when the MULTI-
ZONE control has been switched ON.
2 Press CONTROL.
• When the receiver is on,
any operations for the sub zone are done
while ZONE 2 shows in the display. If this is
not showing, the front panel controls affect
the main zone only.
3 Use the INPUT SELECTOR dial to select
the source for the zone you have selected.
For example, Z2: CDR sends the source
connected to the CDR inputs to the sub room
(ZONE 2).
Note
1 If the receiver is in standby, the display is dimmed, and ZONE2 ON continues to show in the display.
2 The tuner cannot be tuned to more than one station at a time. Therefore, changing the station in one zone also changes the
station in the other zone. Please be careful not to change stations when recording a radio broadcast.
3 • You won't be able to switch the main zone off completely unless you've switched off the MULTI-ZONE control first.
• If you don't plan to use the MULTI-ZONE feature for a while, turn off the power in both the sub and main rooms so that this
receiver is in standby.
• Volume level cannot be adjusted with this receiver. Use the separate amplifier connected to the ZONE2 OUT to adjust the
volume.
48
En
AUDIO / VIDEO MULTI- CHANNEL RECEIVER
TUNE + TUNER EDIT PRESET – PRESET + ENTER
STEREO/ ADVANCED STANDARD MULTI-ZONE MULTI-ZONE
SPEAKERS
A.L.C. SURROUND SURROUND CONTROL CONTROL ON/OFF ON/OFF
iPod VIDEO INPUT
USB VIDEO L AUDIO R
PORTABLE
MULTI-ZONE
CONTROL ON/OFF
1
make sure that
• If you select TUNER, you can use the tuner
controls to select a preset station (see
Saving station presets on page 49 if you're
unsure how to do this).
4 When you're finished, press CONTROL
VSX–819H
again to return to the main zone controls.
You can also press the MULTI-ZONE ON/OFF
button on the front panel to switch off all
MASTER
VOLUME
output to the sub zone.
MULTI-ZONE remote controls
Press the RECEIVER button on the remote
control, then with the SHIFT button pressed,
press the buttons below to operate the
corresponding zone.
The following table shows the possible MULTI-
ZONE remote controls:
Button What it does
ZONE 2
Switches on/off power in the sub zone.
a
ON/OFF
INPUT
Use to select the input source in the
SELECT
sub zone.
MULTI
Use to select the input source directly
CONTROL
in the sub zone.
buttons
a. Without pressing the SHIFT button, you can
switch power on/off in the sub zone.
2
3