Using the MULTI-ZONE feature
Using the MULTI-ZONE controls
The following steps use the front panel controls
to select sources. See MULTI-ZONE remote
Press the MULTI-ZONE ON/OFF button
on the front panel.
Each press selects a MULTI-ZONE option:
• ZONE 2 ON – Switches the MULTI-ZONE
• ZONE 2 OFF – Switches the MULTI-ZONE
The ZONE indicator lights when the MULTI-
ZONE control has been switched ON.
• When the receiver is on,
any operations for the sub zone are done
while ZONE 2 shows in the display. If this is
not showing, the front panel controls affect
the main zone only.
Use the INPUT SELECTOR dial to select
the source for the zone you have selected.
For example, Z2: CDR sends the source
connected to the CDR inputs to the sub room
1 If the receiver is in standby, the display is dimmed, and ZONE2 ON continues to show in the display.
2 The tuner cannot be tuned to more than one station at a time. Therefore, changing the station in one zone also changes the
station in the other zone. Please be careful not to change stations when recording a radio broadcast.
3 • You won't be able to switch the main zone off completely unless you've switched off the MULTI-ZONE control first.
• If you don't plan to use the MULTI-ZONE feature for a while, turn off the power in both the sub and main rooms so that this
receiver is in standby.
• Volume level cannot be adjusted with this receiver. Use the separate amplifier connected to the ZONE2 OUT to adjust the
AUDIO / VIDEO MULTI -CHANNEL RECEIVER
make sure that
• If you select TUNER, you can use the tuner
controls to select a preset station (see
Saving station presets on page 37 if you're
unsure how to do this).
When you're finished, press CONTROL
again to return to the main zone controls.
You can also press the MULTI-ZONE ON/OFF
button on the front panel to switch off all
output to the sub zone.
MULTI-ZONE remote controls
control, then with the SHIFT button pressed,
press the buttons below to operate the
The following table shows the possible MULTI-
ZONE remote controls:
What it does
Switches on/off power in the sub zone.
Use to select the input source in the
Use to select the input source directly
in the sub zone.
Without pressing the SHIFT button, you can
switch power on/off in the sub zone.
b. In ZONE 2, you cannot select MULTI IN inputs.
button on the remote