Connecting A Usb Device; Connecting Your Usb Device To The Receiver; Basic Playback Controls - Pioneer VSX-819H-S Operating Instructions Manual

11 Other connections

Connecting a USB device

It is possible to listen to two-channel audio
using the USB interface on the front of this
receiver. Connect a USB mass storage device
as shown below.
• Push down on the PUSH OPEN tab to
access the USB terminal.
USB
MULTI-ZONE
SPEAKERS
CONTROL ON/OFF
iPod
USB VIDEO
USB mass
storage device
Connecting your USB device to the
receiver
1 Switch on the receiver and your TV.
2 Press iPod USB on the remote control to
switch the receiver to the iPod USB.
NO DEVICE appears in the OSD.
3 Connect your USB device.
The USB terminal is located on the front panel.
Note
1 This includes playback of WMA/MP3/MPEG-4 AAC files (except files with copy-protection or restricted playback).
2 • Compatible USB devices include external magnetic hard drives, portable flash memory (particularly keydrives) and digital audio
players (MP3 players) of format FAT16/32. It is not possible to connect this receiver to a personal computer for USB playback.
• Pioneer cannot guarantee compatibility (operation and/or bus power) with all USB mass storage devices and assumes no
responsibility for any loss of data that may occur when connected to this receiver.
• With large amounts of data, it may take longer for the receiver to read the contents of a USB device.
3 Make sure the receiver is in standby when disconnecting the USB device.
4 • If the file selected cannot be played back, this receiver automatically skips to the next file playable.
• When the file currently being played back has no title assigned to it, the file name is displayed in the OSD instead; when
neither the album name nor the artist name is present, the row is displayed as a blank space.
• Note that non-roman characters in the playlist are displayed as
• It is not possible to output the USB audio to ZONE 2.
64
En
iPod VIDEO INPUT
VIDEO L AUDIO R
MASTER
VOLUME
VIDEO INPUT
L AUDIO R
MCACC
SETUP MIC
This receiver
3
Loading appears in the OSD as this receiver
starts recognizing the USB device connected.
After the recognition, a playback screen appears
1
in the OSD and playback starts automatically.
2
 P L AY
U S B
M P 3
R e l a x Yo u r B o d y
K e v i n J a c k s o n
W e a r e a l l o n e
   3 2 k b p s

Basic playback controls

The following table shows the basic controls on
the remote for USB playback. Press iPod USB
to switch the remote control to the iPod USB
operation mode.
Button What it does
 Starts normal playback.

Pauses/unpauses playback.
/ Press to skip to previous/next track.
 
/ Press and hold during playback to
start scanning.
Press repeatedly to switch between
Repeat Folder, Repeat One and
Repeat All.
Press repeatedly to switch between
Shuffle On and Shuffle Off.
DISPLAY
Press repeatedly to change the song
playback information displayed in the
front panel display.
.
File/Folder number
File format
0 0 1 / 0 0 4
Repeat or Shuffle
R : F l d S : O n
Song name
Artist name
Album name
Elapsed time
0 : 0 1
R e t u r n
Bit rates
4