I.link Messages; Usb Interface; Hdmi - Pioneer VSX-72TXV-S Operating Instructions Manual

Additional information

i.LINK messages

You may see the following messages displayed in the front panel display when using the i.LINK interface.
Message
BUS FULL
CANNOT LINK 1
CANNOT LINK 2
LINK CHECK
LOOP CONNECT
NO NAME
NO SIGNAL
PQLS OFF
PQLS ON
UNKNOWN

USB interface

Symptom
No sound.

HDMI

Symptom
The HDMI indicator blinks
continuously.
No picture or sound.
No picture.
No sound, or sound suddenly
ceases.
Explanation
The i.LINK bus has reached its capacity and cannot transmit any more data.
The connection between the receiver and the selected i.LINK-equipped component is unstable. If the
i.LINK cables appear to be connected properly and both the receiver and i.LINK-equipped component are
on, switch both units off, then on again to re-establish the connection between them.
The receiver can't identify the selected i.LINK-equipped component. For example, the receiver may not be
able to identify an i.LINK-equipped personal computer.
The receiver is checking the i.LINK network. It does this when components are added to, or removed from
the network. The sound may be interrupted if this happens during playback.
The i.LINK network cannot function because the connected components form a loop. See Creating an
i.LINK network on page 50 for more on this.
When an i.LINK-equipped component has no name, this message is displayed instead of the proper
component name.
A component is outputting an i.LINK signal that the receiver cannot reproduce. This receiver can only
reproduce signals from i.LINK-Audio-equipped components. See About i.LINK on page 50 for more on this.
This is displayed on a playback component when PQLS turns off during playback. The sound may be
interrupted momentarily when this happens.
This is displayed on a playback component when PQLS turns on during playback. The sound may be
interrupted momentarily when this happens.
When an i.LINK-equipped component name cannot be recognized, this message is displayed instead of
the proper component name.
Remedy
• Make sure you have set up your computer system to output through the USB interface (see Using the USB
interface on page 52).
• Make sure your computers output level is turned up.
• Update to a more recent version of your software, try a different audio program, or try a different source.
Remedy
• Check all the points below.
• This receiver is HDCP-compatible. Check that the components you are connecting are also HDCP-
compatible. If they are not, please connect them using the component, S-video or composite video jacks.
• Depending on the connected source component, it's possible that it will not work with this receiver (even
if it is HDCP-compatible).
• If the problem still persists when connecting your HDMI component directly to your monitor, please
consult the component or monitor manual or contact the manufacturer for support.
• If your display device is not SD (480i) compatible then neither the setup screens or the 480i to HDMI
converted video will be displayed. In this case, connect using the component, S-video or composite video
jacks.
• Depending in the output settings of the source component, it may be outputting a video format that can't
be displayed. Change the output settings of the source, or connect using the component, S-video or
composite jacks.
• Check that the HDMI AV setting is set to AMP/THROUGH.
• If the component is a DVI device, use a separate connection for the audio.
• If analog video is being output over HDMI then there will be no HDMI audio output. Please use a separate
connection for the audio.
• Check the audio output settings of the source component.
12
79
En