Sequence; Using Multi Operations; Using System Off - Pioneer VSX-72TXV-S Operating Instructions Manual

Controlling the rest of your system
5 Use to select a command in the sequence then
press ENTER .
If this is the first command in the sequence, select 1ST
CODE. Otherwise, simply choose the next command in
the sequence. PRES KEY flashes after you press ENTER.
6 If necessary, press the input source button for the
component whose command you want to input.
This is only necessary if the command is for a new
component (input source).
7 Select the button for the command you want to
input.
The following remote control commands can be
selected:
SYSTEM OFF
INPUT
RECEIVER SOURCE
SELECT
CD TV VIDEO 2
DVD SAT VIDEO 1 TV CONT
DVR2 CD-R
XM RADIO ROOM2/3
DVR1 i Pod TUNER RECEIVER
SLEEP VIDEO ANALOG
SEL ATT
SR+ DIMMER
D.ACCESS CLASS
+10 DISC
ENTER
AV PARAMETER CH LEVEL
TOP MENU ì
MENU
TUNE
ST ST
DTV MENU T.EDIT
ENTER
SETUP RETURN
TUNE
CATEGORY
BAND
GUIDE
TV CONTROL
• You don't need to program the receiver to switch on
or off. This is done automatically.
With Pioneer components, you don't need to:
• program the power to switch off in a shutdown
sequence (except DVD recorders);
• program the power to switch on if it's the source
component selected in step 3;
• program a Pioneer TV or monitor to switch on if the
input function (selected in step 2) has video input
terminals;
These take priority in multi operations (not shutdown).
8 Repeat steps 5–7 to program a sequence of up to
five commands.
9 When you're finished, use
from the menu and press ENTER .
You will return to the remote control SETUP menu. Select
* EXIT * again to exit.
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.
TV CONTROL
INPUT
TV CH VOL
TV VOL
SELECT
REC DTV INFO MUTE
MPX REC STOP MEMORY
AUDIO SUBTITLE HDD DVD
DISP CH CH
STATUS SIGNAL SEL SBch STEREO
to select EDITEXIT

Using multi operations

You can start multi operations with the receiver switched
on, or in standby.
STATUS SIGNAL SEL
MULTI OPE THX
SHIFT
PHASE
RECEIVER
1 Press MULTI OPE.
MULTI OP flashes in the display.
2 Press an input source button that has been set up
with a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed automatically.

Using System off

SYSTEM OFF
INPUT
RECEIVER SOURCE
SELECT
CD TV VIDEO 2
DVD SAT VIDEO 1 TV CONT
1 Press MULTI OPE.
MULTI OP flashes in the display.
2 Press SOURCE .
The command sequence you programmed will run, then
all Pioneer components will switch off
receiver.
SBch STEREO
STANDARD ADV. SURR
MCACC S.DIRECT
STATUS SIGNAL SEL SBch STEREO
MULTI OPE THX STANDARD ADV. SURR
SHIFT
PHASE MCACC S.DIRECT
RECEIVER
1
, followed by this
11
71
En