Assigning The Digital Inputs; Enter Button - Pioneer VSX-45TX Elite Operating Instructions Manual

Assigning the Digital Inputs

If you did not hook up your digital equipment in accordance with the default settings for the digital inputs
(see pages 17,19 & 22–23) you need to complete the procedure below. You have to do this in order to tell
the receiver what digital equipment is hooked up to which terminal so the buttons on the remote corre-
spond to what you have hooked up.
VCR2 VIDEO CD
CD-R/ MD/
TUNER
TAPE1 TAPE2
DIMMER LOUDNESS TONE
1 2 3
SIGNAL SEL DNR BASS/TREBLE
5 6 7
VIDEO SEL HI-BIT
9 0
DIRECT ACCESS SEARCH MODE
2
SYSTEM SETUP
MENU
TUNER EDIT
ENTER
AUDIO
MPX
DTV ON/OFF
¶ 8
3-8 2
STANDBY/ON
STANDBY
MOVIE MUSIC ENTER
MULTI JOG
3
System Setup
[ 1. Surround Setup
[ 2. THX CINEMA Setup
[ 3. Input Assign
[ 4. Function Rename
[ 5. PHONO/LINE Setup
[ 6. Multi Room
[ 7. 12V Trigger
[ Exit
4
3.Input Assign
[ Digital-In Select
[ Component-In Select ]
[Exit]
5
Digital-In Select
Digital-1 [ TV/SAT ]
Digital-2 [ DVD/LD
Digital-3 [
Digital-4 [
[Exit]
memo
• The possible digital inputs that can be assigned
are: DVD/LD, TV/SAT, VCR1, VCR2, CD, CD-R,
MD.
• If you assign a digital input to a certain function
(for example DVD/LD) then any digital inputs pre-
viously assigned to that function will automati-
cally be set to OFF. This is because one func-
tion cannot be assigned to two different places.
MULTI
OPERATION
1
RECEIVER
EFFECT/CH SEL
4
+
8
–
+
10 DISC
ENTER
GUIDE
TOP MENU
3-8
TRACK
EXIT
RETURN
DISP MODE
SUB TITLE
MULTI JOG CONTROL
SIGNAL HI-BIT SB CH
SET UP RETURN SELECT HI-SAMPLING MODE BAND
TONE CONTROL
PHONES
SPEAKERS TONE BASS/TREBLE
]
]
]
]
]
]
]
]
]
]
OFF ]
CD ]
Fine Tuning Your System
(If you are continuing from page 89 you can skip the
first two steps.)
1 Turn on the receiver and your TV,
press RECEIVER on the remote
control.
2 Press the SYSTEM SETUP button.
3 Looking at the on-screen display on
your TV, use the 5∞ buttons to
select INPUT ASSIGN. Press the

ENTER button.

4 DIGITAL-IN SELECT should be
selected, if not use the 5∞ buttons
to select it. Press the ENTER button.
5 Use the 5∞ buttons to move
through the different digital inputs
and press the ENTER button.
6 Use the 5∞ buttons select the
component that you hooked up to
that digital in. Press the ENTER
button.
If you're not sure which component is connected to
which digital in, look on the back of the receiver and
check the cables you connected.
7 When you're finished use the 5∞
buttons to select EXIT and press
ENTER.
This exits the DIGITAL-IN SELECT mode.
8 Use the 5∞ buttons to select EXIT
and press ENTER. Then, use the 5∞
buttons to select EXIT and press
ENTER again.
This exits the SYSTEM SETUP mode and returns to
normal operation.
91