The Pioneer Sr System: Operating Other Pioneer Components - Pioneer VSX-45TX Elite Operating Instructions Manual

• Remote operation may not be possible if direct light from a strong fluorescent lamp is shining on the
memo
IR receiver remote sensor window.
• The tuner cannot be tuned to more than one station at a time. Therefore, changing the station in one
room also changes the station in the other room. Please be careful not to change stations when
recording a radio broadcast.
• The volume levels of the main and sub rooms are independent.
• When more than one remote control signal is transmitted at the same time, the receiver does not
operate.
• When operating MULTI ROOM & SOURCE with the MULTI ROOM & SOURCE OUT jacks connected
to a sub room amplifier which bears the PIONEER component with an CONTROL terminals and has a
remote sensor, both the IR receiver and the amplifier may receive remote control commands (making
correct operation impossible). In this case, place the IR receiver and amplifier apart from each other,
and point the remote control directly at the IR receiver during operation.
• If you plan to leave the MULTI ROOM feature off for a lengthy period please turn off the power in both
the sub and main rooms. Make sure the STANDBY indicator turns red and the MULTI ROOM indicator
goes off.
• If you send the SYSTEM OFF command from the sub room by remote control, the power of both
rooms will go off. Please be careful when making a recording in the main room.
The PIONEER SR System: Operating other PIONEER
components
Connecting an optional control cord allows you to operate other PIONEER components simply by pointing the
receiver's remote control at the remote sensor on the front panel of the receiver. The receiver then sends the
remote control signals to the other devices via the CONTROL OUT terminal.
Receiver
• You can also control PIONEER components (and those made by other manufacturers) by pointing the
memo
receiver's remote control directly at the respective component. This type of operation does not re-
quire control cords. All you have to do is recall the appropriate stored settings (see pages 62- 63).
• If you use a remote control hooked up via the CONTROL IN jack with a control cord, you won't be able
to use this unit's remote control.
• If you use this feature make sure an analog (audio and/or video) connection has been made between
the units.
IN
CONTROL
OUT
PIONEER component
with an CONTROL
SETUP
terminals.
S0URCE TV SYSTEM RECEIVER
OFF
DVD/LD TV SAT TV CONT
MULTI CONTROL
VCR1/ VCR2 VIDEO MULTI
DVR OPERATION
CD CD-R/ TUNER RECEIVER
TAPE1
DIMMER INPUT ATT LOUDNESS SPEAKER A/B
1 2 3 4
VIDEO SEL SIGNAL SEL TAPE 2 EFFECT/CH SELL
5 6 7 8
– + +
TONE BASS/TREBLE 10 DISC
9 0 ENTER
DIRECT ACCESS DISP MODE
SYSTEM SETUP REMOTE SETUP
MENU
TUNER EDIT
ENTER
STATUS EXIT
GUIDE RETURN
MPX DTV ON/OFF
¶ 8
EXTRA MENU
– +
TUNING BAND TUNING
1 3 ¡
– +
STATION DTV MENU CLASS STATION
4 7 ¢
CHANNEL – CHANNEL +
TV INPUT INPUT
TV CONTROL
TV VOL MIDNIGHT VOLUME
TV CH
DIGITAL
NR
THX STANDARD STEREO MUTE
/DIRECT
SURROUND LISTENING
ADVANCED ADVANCED MODE
CINEMA CONCERT
(DVD-A/SACD)
ACOUSTIC MULTI CH LISTENING
CAL INPUT CH SELECT LIGHT
Î
Remote Control
Using Other Functions
CONTROL
IN
OUT
To CONTROL IN
terminal of another
PIONEER component
with an CONTROL
terminals.
79