Pioneer Elite VSX-39TX Operating Instructions Manual page 38

initial Set Up
5˜∞ buttons
38
3
AUTO
T.TONE
MANUAL
T.TONE
DVD/LD
TV/SAT
VCR1
VCR2
STANDBY/ON
ENTER
BACK LIGHT
on/off
AUTO
T.TONE
4
MANUAL
T.TONE
3 Using the remote control display,
follow the instructions below to
adjust the speaker levels so that you
hear the test tone at the same
volume from each speaker when
seated in your normal listening
position.
NOTE : The volume of the subwoofer tends to sound
lower than it actually is. You may need to adjust the
level after testing with an actual soundtrack.
n AUTO mode
I
1 Use the +/– (or 5˜∞) buttons to adjust the level of
the speaker outputting the test tone. The tone will
automatically switch between speakers after
sounding for 2-3 seconds.
2 Adjust the level of all speakers.
In MANUAL mode
1 Use the +/– (or 5˜∞) buttons to adjust the level of
the first (the front left) speaker.
2 Press the button on the touch panel for the next
speaker.
3 Repeat 1 and 2 for each speaker.
If you are using a Sound Pressure Level (SPL)
meter
Take the readings from your main listening position
and adjust the level of each speaker to 75 dB SPL (C-
weighted/slow mode).
You can use the 5˜∞ buttons at the bottom of
memo
the remote control instead of the +/– buttons.
4 When all the speaker levels have
been set, press SETUP OK to return
to the SYSTEM SETUP MENU.
The display on the receiver will say RESUME and the
MASTER VOLUME will return to its original position.
SIGNAL STEREO
SELECT
ANALOG SP A
AUTO
Next, proceed to CROSSOVER NETWORK below.
memo
Note that it is also possible to set channel levels
temporarily. Then follow the same procedure as
explained on this page. This function is designed to be
used when you want to change the levels temporarily
to raise the level of one channel. Using this method you
can set speaker levels in different modes, such as,
STEREO, and each DSP mode, independently. You
should return the settings to their original state when
done. Doing the set up procedures on this page will
erase any temporary/independent level settings that
have been made.
VOLUME
dB