Locking The Settings - Pioneer Elite VSX-39TX Operating Instructions Manual

5
DVD:OK
RECEIVER
DVD/LD
TV/SAT
SEARCH
MODE
TOP
VCR1
MENU
VCR2 MENU
SET UP
Learning
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
Some commands from other
memo
remote controls cannot be
learned, but in most cases the
remotes just need to be moved
closer together or farther apart.

Locking the Settings

This feature allows you to lock the SYSTEM SETUP and REMOTE SETUP settings so that they cannot be
changed without unlocking them first. When they are locked you cannot enter the setting screen in these
modes. The locking and unlocking procedures are done by the same process.
Unlocked symbol
Remote Setup
RECEIVER
LCD
DIRECT FUNCTION
COMMANDER
DVD/LD
PRESET RECALL
ITEM MEMO
TV/SAT
LEARNING KEY RENAME
VCR1
MULTI OPERATION
VCR2
MULTI SYSTEM
1 OPERATION
STANDBY/ON
ENTER
BACK LIGHT
on/off
2
Locked symbol
Remote Setup
RECEIVER
LCD
DIRECT FUNCTION
COMMANDER
DVD/LD
6
5 Point the two remote controls toward
BACK
REMOTE
SETUP
1 2 3
MD/TAPE1
4 5 6
CD
7 8 9
TUNER
TV
10 0
C
CONTROL
7
REMOTE
SETUP
MD/TAPE1
CD
6 Press the BACK button to return to the
TUNER
TV
CONTROL
7 When you're done press the BACK
1 In the SYSTEM SETUP or REMOTE SET
use lock
TV
BACK
CONTROL
REMOTE
SETUP
FUNCTION
MD/TAPE1
+
CH
CD
—
CH
+
VOL
TUNER
—
VOL
TV
FUNCTION
CONTROL
MASTER VOLUME
+
2 Press the lock symbol while holding
OFF
MUTING
—
use lock
TV
BACK
CONTROL
REMOTE
SETUP
FUNCTION
MD/TAPE1
memo
+
CH
Remote Control of Other Components
each other. Press the button on the
other remote control corresponding to
the operation you want to program.
LEARNING flashes in the display on the VSX-39TX remote
control. After the process is complete and the command
has been learned, OK will appear at the top of the remote
control LCD display. If NG (no good) appears, it means
that for some reason the command was not learned.
Repeat steps 4 and 5 to teach the remote control of the
VSX-39TX all the commands from the other remote
control.
12-30 cm
(5-12 inches)
LEARNING/SELECT FUNCTION screen.
Start again from step 3 to program all your components in
this manner.
button repeatedly to return to the
REMOTE SETUP or RECEIVER menu.
UP screens hold down the 5˜∞
buttons at the same time. While you're
holding down the buttons a lock
symbol will appear in the top bar of
the remote control.
down the above two keys. The setting
will either lock or unlock depending on
the state it was previously in.
From that time, if the screen is locked the lock symbol
will appear when that screen is accessed.
The only exception to LOCKING THE SETTINGS is the
LCD COMMANDER settings in the REMOTE SETUP
screen. They can still be accessed even when the
REMOTE SETUP screen is locked.
61