Azden 105UPR User Manual page 7

Operating the system
Because this is a frequency agile system, the receiver and transmitter must be on the same
Receivenransmit frequency. Follow the instruction #5,16,24 and 27. Make sure both the
receiver and transmitter are on the same channel.
105U PR Receiver
After installing new batteries, mount the receiver to your video camera with the supplied
shoe mount or hook & loop fastener. Connect the output cable to the receiver and to the
microphone input on the vide mmera. Switch the 105UPR to "ON" and the power
6
indicator (7) should come o
I ?
,~ed'?
If it doesn't, check the batteries. When the 105UPR
receives a signal from the transmitter the LED indicator will change t m e n : If it does not,
4
make sure both the receiver and transmitter are on matching channhs:
15BT Transmitter
Plug in the supplied lapel microphone and clip it to your subject. The microphone should be
placed 4-12 inches from your subject's mouth. Clip the transmitter to a belt using the
supplied belt-clip or place it in a pocket. Switch the 15BT to "ON" and the power indicator
should come on. If it does not, check the batteries. Have someone speak into the
microphone as you monitor the sound through the receiver's phone output. If the sound is
distorted lower the MIC input level on the transmitter. If there is not enough volume raise the
MIC input level on the transmitter.
;
15XT Transmitter
Switch the transmitter to "ONn and the power indicator should come on. If it does not, check
the batteries. Have someone speak into the microphone as you monitor the sound through
the camera's monitor output. If the sound is distorted lower the level control on the
transmitter. If there is not enough gain raise the level control on the transmitter.
35HT Transmitter
Switch the transmitter to "ONn and the power1 indicator should come on. If it does not, check
the batteries. Have someone speak into the microphone as you monitor the sound through
the camera's monitor output. If the sound is distorted lower the level control on the
transmitter. If there is not enough gain raise the level control on the transmitter.
Important information
Licensing of this, or any k d e n wireless equipment Is the user's responsibility. The ability to receive a license depends largely on the
user's classification, application and frequency. Contact the appropriate agency (FCC in the US) for further information.
These devices comply with Part 15 of the FCC Rules. Operation is subject to
Ule
following
two
conditions: (1) These devices may not
cause harmful interference, and
(2)
These devices must accept any interference received, Including interference that may cause
undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized mdifications to this equipment
Such modifications could w i d the u s e k authority to operate the equipment.
These devices and their antenna@) must not be co.located or operated in conjunction with any other antenna or transmitter.
5