Azden 105UPR User Manual page 3

Thank you for purchasing Azden's 105 wireless microphone system. Depending on
which system you ordered this package will contain one or more of the following compo-
nents: the 105UPR receiver, the 15BT body-pack transmitter with EX-503L lavalier mi-
crophone, the 15XT XLR plug-in transmitter andlor the 15HT handheld microphone
transmitter. This equipment is designed primarily for video cameras but is usable with
most electronic components having a microphone level input. The 105UPR allows you to
"receive" audio from one transmitter at a time.
RECEIVER (105UPR)
*
(1) Remove the battery compartment lid by sliding it down.
(2) Insert two fresh Alkaline* "AA" batteries into the compartment. Make sure the battery
.2,
polarity is correct as marked inside the battery compartment.
(3) POWER:
Switches the receiver "ON" or "OFF".
(4) MIC OUT jack:
The 105UPR is supplied with a mini-to-mini cable.
For mini jack microphone inputs: Use the supplied mini-to-mini cable. Plug one
end of the cable into the receiver and the other end of the cable into the micro-
phone input of the video camera.
For 3-pin XLR microphone inputs: Use the optional mini-to-XLR cable (MX-1).
Plug the mini-plug end of the cable into the receiver (use the screw-down sleeve
to secure it to the receiver) and plug the XLR end of the cable into the micro-
phone input of the video camera.
i
(5) Frequency Selection:
Frequency adjustment is accomplished by setting the controls inside the battery com-
partment. With the frequency GROUP dial on the left (column A on the included chart)
you can select any of 10 frequency groups (numbered 0-9). With the frequency CHAN-
. 1
NEL dial on the right (column B on the included chart) you can select any of 10 frequency
channels (numbered 0-9). There are 92 possible combinations.
(6) Phone Jack:
Plug an earphone into this jack to monitor the sound. The jack is wired to work with either
mono or stereo headphones (you will hear mono in both ears).
(7) LED indicator:
This LED turns RED when the receiver is turned "ON" and GREEN when receiving a
signal from the transformer.