Azden 105UPR User Manual page 4

(8) Phone Output Adjustment: Using the supplied tool, turn the screw clockwise to in-
crease earphone level and counterclockwise to decrease.
(9) Shoe-Mount:
Attach the 105UPR to the shoe-mount of the video camera by sliding it into place. Turn
the thumbwheel clockwise to tighten. Reverse this procedure to remove.
(10) Antenna: For best reception the antenna should be pointed in an upward fashion.
Use caution, and do not force it into this position.
BODYPACK TRANSMITTER (15BT)
3
(1 1) Remove the battery compartment lid by sliding it down.
\
2
(12) Insert two fresh "AA" Alkaline* batteries into the compartment. Make sure the bat-
tery polarity is correct as marked inside the battery compartment.
In addition to the battery, inside the battery compartment you will find:
(13) MIC lnput LEVEL Control:
This control enables you to adjust the input level of the microphone. Using the supplied
tool, turn the dial clockwise to increase, or counterclockwise to decrease the input level.
(14) POWER:
Switches the transmitter "ON" or "OFF",
(15) MIC lnput Jack:
Plug the supplied EX-503L microphone into the MIC input jack and tighten the collar until
snug (DO NOT OVERTIGHTEN). In addition to the EX-503L, other lapel andlor headset
microphones with 3.5mm mini plugs can also be used wi t hi t he 15BT.
(1 6) Frequency Selection:
Frequency adjustment is accomplished by setting the controls inside the battery com-
partment. With the frequency GROUP dial on the left (column A on the included chart)
you can select any of 10 frequency groups (numbered 0-9). With the frequency CHAN-
NEL dial on the right (column B on the included chart) you can select any of 10 frequency
1;
channels (numbered 0-9). There are 92 possible combinations.
i'
(17) Audio Standby:
The AudiolStandby switch ierves as a mute switch. In the STBY position the audio out-
put from the 15BT is muted while in the ON position audio is transmitted.
(1 8) Belt clip