Azden 105UPR User Manual page 5

XLR PLUG-IN TRANSMITTER (15XT)
(19) Open the battery compartment lid and insert 2 fresh "AA" Alkaline batteries. Make
sure the battery polarity is correct as marked inside the battery compartment
(20) POWER:
Switches the transmitter "ON" or "OFF"
(21) AUDIO:
Prior to first turning the 15XT "ON" it is best to set the AUDIO switch to "OFF". When
'i
you are ready to begin transmitting, switch to "ON". The "OFF" position acts as a
'mutete" that maintains the RF signal but turns off the audio.
(22) MIC ConnectorlLocking Ring:
This 3-pin XLR connector is the microphone input. Any low impedance microphone
with a corresponding connector can be attached here. Once the microphone is plugged
into the 15XT the locking ring should be rotated clockwise until snug. To remove the
microphone, first rotate the locking ring counterclockwise and then, while pressing the
XLR release, pull the microphone away from the 15XT.
(23) MIC Input LEVEL Control:
The MIC input LEVEL control enables you to adjust the inpd level.of the connected
microphone. Using the supplied tool, turn the dial clockwise to increase, or counter-
clockwise to decrease the input level.
(24) Frequency Selection:
Frequency adjustment is accomplished by setting the controls ingMe the battery com-
partment. With the frequency GROUP dial on the left (column A on the included chart)
you can select any of 10 frequency groups (numbered 0-9). With the frequency CHAN-
NEL dial on the right (column B on the included chart) you can select any of 10 fre-
quency channels (numbered 0-9). There are 92 possible combinations.