Hitachi WH 18DBFL2 Safety And Instruction Manual page 14

English
(1) Removing the hook.
Remove the screws fi xing the hook with Philips screw
driver. (Fig. 9)
Hook
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fi x the hook fi rmly.
(Fig. 10)
Hook
7. About Remaining Battery Indicator
Remaining battery power can be verifi ed by pulling on
the switch to light up the remaining battery indicator
lamp. (Fig. 11)
The indicator lamp will turn off 10 seconds after the
switch is released.
The Table 5 shows the state of remaining battery
indicator lamp and the battery remaining power.
State of lamp
14
Groove
Screw
Fig. 9
Groove
Screw
Fig. 10
Table 5
Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power
is a half.
The battery remaining power is
nearly empty.
Re-charge the battery soonest
possible.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
Display panel
Remaining battery
indicator lamp
NOTE
Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
8. How to use the LED light
While the switch is pulled, the LED light will
automatically light up the tip portion of the tool.
(Fig. 12)
The LED light will automatically turn off 10 seconds
after the switch is released.
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
Switch trigger
Fig. 11
Switch trigger
Fig. 12