Cautions For Use; Maintenance; Troubleshooting - EYENIMAL Bark Control Soft User Manual

Checking the device operates correctly
- Switch on the collar (turn the collar on mode 3, thus you will be able to check the operation of
ultrasounds and vibrations).
- Slowly rub the sensor on a slightly rough surface (change the detection sensitivity if necessary).
- The collar will emit ultrasounds and/or vibrations (according to the chosen configuration).
IMPORTANT: after being activated 5 times in quick succession, the collar will automatically go
into safety mode for 15 seconds, before restarting itself normally.

Cautions for use

- The collar should be used on dogs only over 6 months old.
- Before using the collar, it is important to have your dog checked by your vet to ensure it is fit
to wear a bark limiter.
- The collar is weatherproof but not waterproof.
- To avoid unintentional triggering, the dog should not wear a medal, metallic collar, or any
other kind of collar together with the bark limiter collar.
- If you do not use the collar for a long period of time, we advise you to remove the battery. Never
leave a discharged battery in the collar.
- Keep the collar out of reach of children.

Maintenance

Do not use volatile liquids such as solvents or benzene to clean your bark limiter collar. Use a
soft cloth, slightly moistened with water or a neutral detergent. The nylon strap can be washed
with soapy water.

Troubleshooting

Before thinking your collar is broken, read this booklet over and make sure that the problem is
not caused by a weak battery or by a sensor screwed too tightly.