Checking Your System Settings; Resetting The System; Default Amplifier Settings - Pioneer VSA-AX10Ai Operating Instructions Manual

Using other functions

Checking your system settings

Use the status display screen to check the various
settings you've made for features such as sound delay,
digital noise reduction, and high-sampling.
1 From the remote control amplifier menu, press
STATUS to check the system settings.
You may need to press
AMPLIFIER
first before reaching the amplifier menu screen shown
below (use the (cursor left/right) soft keys to go to
the previous/next menu screen).
AMPLIFIER
AMPLIFIER
INPUT
SPEAKER
A/B
VIDEO
SELECT
TAPE2
MONITOR
These appear on both the OSD and the front panel
display.
SB CH MODE :
ACOUS. CAL EQ
DIGITAL NR :
MIDNIGHT
LOUDNESS :
TONE CONTROL :
VIDEO SELECT :
DUAL MONO :
SOUND DELAY :
HI-BIT :
HI-SAMPLING :
REAL PHANTOM :
The front panel display shows each of the following
settings for two seconds each:
Surround back speaker/
Virtual back speaker
Acoustic calibration EQ
Digital noise reduction
Midnight
Loudness
Tone
Note
• If the Stream Direct mode is switched on, some
settings above will show OFF, even though they are
switched on.
2 When you're finished, press STATUS again to
switch off the display.
on the Home menu (
3/3
TV
CONT
SB CH
MODE
INPUT
ATT
DISPLAY
DIMMER
STATUS
OFF
: ALL ADJ
OFF
: ON
OFF
OFF
DVD/LD
CH1
0.0frame
OFF
OFF
OFF
Video select
Dual mono
Sound delay
Hi-bit
High-sampling
Real phantom

Resetting the system

Use this feature to reset the system to its factory default
settings (see Default amplifier settings below).
1 Switch the amplifier into standby.
2 While holding down the front panel DIGITAL NR
button, press and hold
)
three seconds.
The display shows RESET?.
3 Press the front panel OPTION + button.
The display shows OK?.
4 Within 5 seconds, press OPTION –.
The amplifier should now be reset.
Note
• This doesn't affect the presets that you have
programmed into the remote control (see Using the
remote control with other components on page 61).
See Resetting the remote control on page 10 to do
this.

Default amplifier settings

The table below shows the factory default settings. When
you reset the system, the amplifier reverts to these
defaults:
Setting type Default setting
DVD/LD
Input
Master volume – – – dB (no sound)
STANDARD (video inputs,
Listening mode
multichannel inputs, USB)
STEREO (audio inputs)
90 (5/7CH STEREO)
Advanced surround
effect level 50 (all other modes)
STEREO
Listening mode (w/
headphones)
SD:1 NORMAL (ON)
Stream Direct mode
Acoustic Calibration OFF (switches to ALL CH ADJ
EQ after the Auto Surround Setup)
AUTO except multichannel
Input signal select
inputs (ANALOG) and USB
(DIGITAL)
USB / multichannel 8 channels
input channel setting
Surround Back ON (with surround back
Channel mode speaker(s) connected)
OFF
Virtual Surround Back
mode
OFF
Hi-bit/Hi-sampling
STANDBY/ON for about
Page ref.
page 39
page 41
page 42
page 43
page 44
page 44
page 45
page 46
page 47
page 48
08
73
En