JVC SR-VS30U Service Manual page 10

3.2.3 Removing the FM bracket/Capstan motor assembly
(Mechanism A and B)
(1) Remove soldering of connector FM on reel motor board.
(Fig.13)
(2) Remove three screws B and disengage two pawls, and
then the FM bracket and the capstan belt can be removed.
(Fig.13 and 14)
(3) Remove two screws C retaining the capstan motor from the
FM bracket. (Fig.13)
(4) For reengaging the capstan belt, refer to Fig.14.
3.2.4 Removing the flywheel assembly
(Fig.15)
(1) Remove two screws D and remove the shield plate.
(2) Pull up the flywheel (L) and (R), and remove them.
3.2.5 Removing the reel motor board
(Fig.15)
(1) Remove four soldering of the reel motor and actuator mo-
tor, and remove the reel motor board.
1-10 (No.MB061)
Connector FM
Reel motor board
Pawl
FM bracket
B
Fig.13
Fig.14
Actuator motor
Reel motor
Soldering
Flywheel (R)
Fig.15
Capstan motor
B
C
Pawl
B
Capstan belt
Soldering
Reel motor board
Shield plate
Flywheel (L)