Table of Contents
Advertisement
Figure 7.7 – Fuse Box Layout
Fuses are located on top of the engine near the intake.
To remove or inspect a fuse, remove molded plastic
cap from fuse holder. Inspect fuse and replace if it is
defective. Make sure to replace the fuse block cover
when finished.
© 2016 Indmar Marine Engines
WIRING
If during maintenance or inspection, it becomes
necessary to move or reposition any of the engine's
wiring or wire harnesses, verify that wiring is returned
to its original position, and that all harnesses are routed
correctly. If a wiring clip or retainer breaks, replace it
immediately. Wiring is specifically routed to eliminate
problems related to engine heat and spray, immersion
in liquids, or contact with rotating assemblies. Electrical
problems can result if wiring is moved from its original
position and is not properly repositioned.
Charging System Maintenance / Guidelines
INDM-0017
Adhering to the following procedures and guidelines will
ensure proper operation of your battery charging system.
Watch out for:
1. REVERSE BATTERY POLARITY: When
reconnecting the battery after winter storage, it is
easy to accidentally reverse the battery leads and
connect positive to negative and negative to positive.
This generally results in a large arc at the battery
terminals and
in the alternator as well as other components in
the electrical system of the engine or boat that are
MAINTENANCE
failure of the diodes and/or regulator
7-13
Advertisement
Table of Contents
