Specifications - Pioneer CP-2EX Operating Instructions Manual

Assembly with a separate speaker system
If you are using a speaker system other than the S-2EX, note
that you will have to use a hand drill (or the like) to make
holes on the speaker base to secure it to the stand. Make
sure the speaker weight does not exceed 29 kg.
After making holes on the speaker base where indicated
(make sure they line up with the screw holes on the speaker
support), secure the speaker to the speaker support using
commercially available wood screws as shown below.
Speaker
base
Speaker
support
Cabinet and stand maintenance
• Use a polishing cloth or dry cloth to wipe off dust and
dirt.
• If the cabinet or stand is very dirty, use a soft cloth
dipped in some neutral cleanser diluted 5 or 6 times
with water. Finally, wipe again using a dry cloth. Do not
use furniture wax or cleaners.
• Never use thinners, benzine, insecticide sprays and
other chemicals on or near the cabinet or stand, since
these will corrode the surfaces.
4
En
Fastening nut
Screw holes
for securing
speaker
Commercially
available wood
screw

Specifications

External dimensions
.................................. 400 (W) mm x 604 (H) mm x 513 (D) mm
3
15 / (W) in. x 23
4
Weight ....................................................... 17.8 kg / 39 lbs. 4 oz.
Supplied accessories
Stand base plates ...................................................................... 2
Speaker supports ....................................................................... 2
Stems .......................................................................................... 4
Spikes (with attached nuts) [SBA6053] ................................... 8
Spike bases [SLA1057] .............................................................. 8
Screws (Bind head, M5xL62) [SBA6050] ................................. 4
Screws (Bind head, M5xL36) [SBA6048] ................................. 4
Screws (Bind head, M6xL40) [SBA6054] ............................... 24
Spring washers [SBE6005] ........................................................ 4
Washers [SBE6006] ................................................................... 4
Operating instructions [SRD6056] ........................................... 1
• Specifications and design subject to possible modifica-
tion without notice, due to improvements.
• The product number are listed above in square brackets.
Replacement part numbers
Part name
• Protector (Bottom)
• Protector (Middle)
• Protector (Top)
• Protector
• Packing case
• Protection sheet
• Protection sheet
• Protection sheet
Published by Pioneer Corporation.
Copyright © 2006 Pioneer Corporation.
3 3
/ (H) in. x 20 / (D) in.
4 16
Part no.
SHA6095
SHA6096
SHA6097
SHA6098
SHG6129
SHC6044
SHC6045
SHC6046
All rights reserved.