Transmitter Battery Installation; Tips For Achieving Maximum Performance - Pyle PDWM 4520 Manual

The audio gain control on transmitter has been factory-at the mid-range position
for best performance in most applications.This may be necessary for soft singers
or talkers, or guitar or basses with Iow outputs.
To Increase Gain: Rotate the transmitter gain control clockwise with the
screwdriver to increase audio gain.
To Reduce Gain: Rotate the transmitter gain control counterclockwise with the
screwdriver to reduce audio gain.
To return audio gain to the factory setting, rotate the transmitter audio gain
control to the mid position.

TIPS FOR ACHIEVING MAXIMUM PERFORMANCE

Make sure you can always see a receiver antenna from the transmitter position.
Keep the distance from transmitter to receiver antenna as short as possible.
Point receiver antennas away from each other at a 45 angle from vertical.
Avoid placing the receiver antennas near metal surfaces and obstruction.
Monitor battery fuel gauge and replace battery as soon as red light is on.
If stacking or rack mounting receivers in a multiple-system use situation,do not
allow antennas to touch or cross.
Perform a walk-through before Performance or Presentation .If dead spots are
found, adjust location of receiver .If dead sports remain ,mark spots and avoid.
9

TRANSMITTER BATTERY INSTALLATION

1. Battery Installation of Handheld Microphone: Open the battery cover,
Insert the supplied batteries into battery jar in polarity and cover the battery
cover.
2. Battery Installation of Bodypack Transmitter:Push open the battery cover,
Insert the supplied batteries into battery jar in polarity and close the battery
cover.
Push down
to open.
Push down
to open.
6