Tuner Settings - Pioneer PRV-9200 Operating Instructions Manual

The Initial Setup menu
Setup Navigator
• Default setting: n/a
Initial Setup
Basic Clock Setting
Tuner Input Line System
Video In/Out On Screen Display
Audio In Front Panel Display
Audio Out Remote Control Set
Language Setup Navigator
Recording
Playback
The Setup Navigator appears automatically when you
switch on the recorder for the first time (or after resetting
the recorder). It is also available from the Initial Settings
menu should you need it at any other time.
See also Switching on and setting up on page 25.

Tuner settings

Auto Channel Setting
• Default setting: Antenna
Initial Setup
Basic Auto Channel Setting
Tuner Manual CH Setting
Video In/Out VCR Plus+ CH Setting
Audio In
Audio Out
Language
Recording
Playback
Auto Channel Setting automatically tunes the built-in TV
tuner to terrestrial broadcast TV channels or cable
channels. Select Antenna or Cable, depending on how
you receive your TV channels, then wait for the automatic
tuning to finish.
Tuning
Cancel
After automatic tuning, a summary channel mapping
screen is displayed.
Initial Setup
Channel Mapping Antenna
CH Skip CH Skip
9 Off
Off Off
2 10
3 Off 11 Off
4 Off 12 Off
5 Off 13 Off
Off Off
6 14
7 Off 15 Off
8 Off 16 Off
Press ENTER to return to the main menu screen.
Start
Antenna
Cable
7/68
1/3
CH Skip CH Skip
17 Off 25 Off
Off Off
18 26
19 Off 27 Off
20 Off 28 Off
21 Off 29 Off
Off Off
22 30
23 Off 31 Off
24 Off 32 Off
Note
• If you want to cancel before tuning has finished,
press ENTER.
• You can manually tune and skip blank channels
using the Manual CH Setting, below.
Manual CH Setting
• Default setting: n/a
The channel skip function lets you skip channels where
there is no station so that as you change channels using
the CHANNEL +/– buttons or the number buttons, you
only change to channels that have a station.
The manual tuning function allows you to manually tune
to stations, should you need to.
Initial Setup
Basic Auto Channel Setting
Tuner Manual CH Setting
Video In/Out VCR Plus+ CH Setting
Audio In
Audio Out
Language
Recording
Playback
1 From the manual channel setting screen:
• Use the CHANNEL +/– button to change channels.
• If you want to skip the displayed channel (because
there is no station assigned to that channel), change
the Skip setting to On.
• If you want to manually tune the displayed channel,
change the AFT (Auto Fine Tuning) setting to Off,
then move down to Level to manually tune to a
station.
Skip
AFT
Level
• To return to the Initial Setup menu, press ENTER.
VCR Plus+ CH Setting
• Default setting: n/a
Guide channels are used by the VCR Plus+ system so
that the channel number specified in the VCR Plus+
programming numbers can be guaranteed to
correspond to the correct station.
Next Screen
2ch
Off
Off
0
13
97
En