What's In The Box; Putting The Batteries In The Remote Control; Using The Remote Control - Pioneer PRV-9200 Operating Instructions Manual

Pioneer dvd recorder prv-9200 operating instructions
Hide thumbs Also See for PRV-9200:
Table of Contents

Advertisement

Before you start
01

What's in the box

Please confirm that the following accessories are in the
box when you open it.
• Remote control
• AA/R6P dry cell batteries x2
• Audio/video cable (red/white/yellow)
• RF antenna cable
• Power cable
• These operating instructions
• Warranty card
Putting the batteries in the remote
control
1
Open the battery compartment cover on the
back of the remote control.
2
Insert two AA/R6P batteries into the battery
compartment following the indications ( , ) inside
the compartment.
3
Close the cover.
10
En
Note
Incorrect use of batteries can result in hazards such as
leakage and bursting. Please observe the following:
• Don't mix new and old batteries together.
• Don't use different kinds of batteries together—
although they may look similar, different batteries
may have different voltages.
• Make sure that the plus and minus ends of each
battery match the indications in the battery
compartment.
• Remove batteries from equipment that isn't going to
be used for a month or more.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction's rules that apply in your country or
area.

Using the remote control

Please keep in mind the following when using the remote
control:
• Make sure that there are no obstacles between the
remote and the remote sensor on the unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the unit's
remote sensor.
• Remote controllers for different devices can interfere
with each other. Avoid using remotes for other
equipment located close to this unit.
• Replace the batteries when you notice a fall off in the
operating range of the remote.
• When the batteries run down or you change the
batteries, the remote control mode and TV preset
codes are automatically reset. See Remote Control
Set on page 96 and Setting up the remote to control
your TV on page 108 to reset them.
• Use within the operating range and angle, as shown.
30
30
23ft
• You can control this recorder using the remote
sensor of another Pioneer component using the
CONTROL IN jack on the rear panel. See Rear panel
connections on page 14 for more information.

Advertisement

Table of Contents
loading

Table of Contents