Table of Contents
Advertisement
Server power features
This section contains information about how to properly turn your server on and off.
Turning on the server
You can turn on the server in any of the following ways:
v If the power cords are connected to a power source, you can press the
v If the server is turned on and a power failure occurs, it restarts automatically
v You can turn on the server by using the optional Remote Supervisor Adapter.
v You can turn on the server by using the Integrated Management Processor
v When you plug in your server for the first time, Wake on LAN
v If your server was previously turned on, it must be properly placed in Standby
Complete the following steps to manually turn on the server:
1. Review the information in "Safety" on page v.
2. Turn on all external devices, such as the monitor.
3. Plug the server power cords into the power source.
4. Press the power-control button on the front of the server.
Note: While the server is powering up, the power-on LED on the front of the server
power-control-button on the front of the server.
Note: You can install a circular disk over the power-control button to prevent
accidental manual power-off. This disk, known as the power-control button
shield, comes with your server.
when power is restored.
(ISMP).
server.
mode for the Wake on LAN feature to turn on the server.
is on.
®
can turn on the
Chapter 2. Installing options
11
Advertisement
Table of Contents
