Advertisement
Step
1
Remove covers
Remove all 3 covers (top and both rear covers)
2
Remove potentiometer
Disconnect potentiometer wires at the terminal board. (Terminals 32, 33, 34, 35, 36 and 37. )
Disconnect potentiometer from mounting plate. Save the nuts for next step.
3
Mount the new potentiometer using saved nuts.
4
Slide the potentiometer actuator sleeve through the potentiometer and over the end of the cam bushing.
Push the sleeve in potentiometer fitting the pin into the slot of the potentiometer.
Page 2 of 5
Table 1 1000 Ohm Installation Procedure
Action
62-86-33-41
Advertisement
