JVC KV-DV7 Service Manual page 9

Replacing the DVD door flame
Prior to performing the following procedure, remove
the front panel assembly and the control switch
board.
1. Remove each button on the back of the front panel.
2. Press the OPEN button on the front side of the front
panel to open the DVD door.
3. Remove the six screws M attaching the DVD door
flame on the back of the front panel.
4. Disengage the three joints f on the top of the DVD
door flame using a screwdriver (-) to pull out the
three bosses of the front panel. Peel off the two
adhesive tapes at the same time.
5. Detach the bottom of the DVD door flame. Press the
lock lever on the front side of the front panel and
remove the DVD door flame from the gear.
CAUTION: When reassembling, reattach the DVD
door flame to the front panel with the
two adhesive tapes while engaging the
three joints f.
Detach the lock lever from the front side, then from the gear.
DVD door flame (remove from bottom)
DVD door flame
Front panel
Adhesive tapes
(See Fig.19 to 24)
Fig.22
Bosses
DVD door flame
Fig.24
Eject button
M
M
Reset button
Control button
Fig.19
Front panel
DVD door
Fig.20
Insert a screwdriver.
Joint f
Adhesive tapes
Fig.21
Fig.23
DVD door flame
M
M
Power button
OPEN button
Joint f
Joint f
DVD door flame
Lock lever
DVD door
KV-DV7
1-9