Removing The Unit - Pyle PLCDBT95MRB User Manual

INSTALLATION
Screw (5x25mm) and Plain Washer) to
attach the other end of metal strap to a
solid metal part of the vehicle under the
dashboard. This strap also helps ensure
proper electrical grounding of the unit.
Note to install the short threading
terminal of the mounting bolt to the back
of the unit and the other long threading
terminal to the dashboard.
Mounting Bolt

Reconnect the cable to the vehicle
battery's negative (-) terminal. Then
replace the outer trim ring.

Removing the unit


Make sure the ignition is turned off,
then disconnect the cable from the
vehicle battery's negative (-) terminal.

Remove the metal strap attached the
back of the unit (if attached).

Lift the top of the outer trim ring then
pull it out to remove it.
Insert both of the supplied keys into the
slots at the middle left and right sides of
the unit, then pull the unit out of the
dashboard.
Spring Washer Hex Nut
Metal Strap
Plain Washer
Tapping Screw
4