Connect Speaker Bar With An Analog Device; Prepare A Remote Controller; Replace A Button Cell Of A Remote Controller - Pioneer SBX-D201 Instruction Manual

SBX-D201

Connect Speaker Bar with an analog device

Connect an analog input terminal of the unit with an analog output terminal of an audio device
using an analog audio cable (diameter of a plug: 3.5 mm).

Prepare a remote controller

Pull out an insulation sheet before use.
 Point a remote controller at an infrared ray receiver when pressing a button. Infrared rays
from a remote controller can reach an object from about 5 m away.

Replace a button cell of a remote controller

Replace the old button cell with a new one (CR2032) if a remote controller does not operate
properly or a signal reaching distance becomes shorter.
1. Slide-open a buttery lid while pressing a hole on the rear side of the remote controller with
a pointed object.
2. Replace the old button cell with a new one (CR2032) according to the indication for cathode
and anode of cell on the remote controller.
3. Close a battery lid.
 Dispose of used button cells in accordance with regulations of the local government or
your community.
14
DC IN 24V AUX INFRARED SPEAKERS HDMI HDMI
IN RECEIVER R L IN (ARC)
DC IN 24V AUX
IN
Analog audio cable
（accessory）
Insulation sheet
Television and
any other
device
LINE OUT